This device allows you to safely and remotely kill your electronic ignition equipped engine from your transmitter.
Igniton system is Optically Coupled to isolate your
igniton system from your radio system. (No Interference!!)
This device features the following:
1. Includes a remote mountable bright LED to indicate when the ignition is armed.
2. Optically coupled input/output.
3. Pic12F675 Controller.
4. Li-Po/Li-lon/A123/Ni-Mh/NiCad battery Input.
5. Up to 20 Volt 16 amp MOS-FET(IRF7456) output.
6. Low to 3Volt 3amp output.
7. Low Voltage Drop-Less than 150mv.
8. 100% Surface Mount Technology for reliabilty.
9. Heavy Gauge Wires,universal connectors.
10.Small and light weight –only 0.3 OZ!(8g)
11.Reverse Bettery input protection.
12. Shutting down the transmitter power or receiver will automatically cut off the engine.
This device plugs into a spare receiver channel, assign to a switch on the TX
This is a must have safety device for any gas powered plane!
This device allows you to safely kill your engine at anytime (on the
ground ,or in the air!)
When TX reception is lost Engine is stopped
Engine also stops if reciever is switched off
Ultimate safety, backs up your failsafe, imagine a receiver battery failure, a servo failure, this will still stop your engine.
New Version, now with BEC, so use any 2-3 cell lipo, life etc for your supply and you will get a stabilized 5v supply to your ignition
- RCEXL OPto Isolated RC Engine Switch